Publication detail

Analysis od delamination in drilling of composite materials

SEDLÁČEK, J. SLANÝ, M.

English title

Analysis od delamination in drilling of composite materials

Type

Peer-reviewed article not indexed in WoS or Scopus

Language

en

Original abstract

The aim of this work is to clarify the interaction mechanisms between the drilling tool and material. Among the defects caused by drilling, delamination appears as to be of the most critical and may occurs at both the entrance and exit plane. This paper presents a prediction Hocheng-Dharan model of thrust force for drilling without delamination. HSS twist drills with different geometry were used for drilling of carbon/epoxy composites. Experiments were performed to validate physical model of delamination and investigate the effect of tool geometry and drilling paramenters on delamination. The results showed that proposed delamination model is adequate and that damage around drilling hole can be reduced significantly by proper selection of drilling conditions.

Keywords in English

composite materials, delamination, drilling, tool wear

Released

2010-07-14

Publisher

MM Science

Location

Praha

ISSN

1803-1269

Journal

MM Science Journal

Volume

Vol. 3

Number

6

Pages from–to

194–197

Pages count

4

BIBTEX


@article{BUT50392,
  author="Jan {Sedláček} and Martin {Slaný}",
  title="Analysis od delamination in drilling of composite materials",
  journal="MM Science Journal",
  year="2010",
  volume="Vol. 3",
  number="6",
  pages="194--197",
  issn="1803-1269"
}