Publication detail

Surface sheets morphology during its division using conventional and unconventional technologies

DVOŘÁK, M. KALIVODA, M. OSIČKA, K. MOURALOVÁ, K. SLANÝ, M.

English title

Surface sheets morphology during its division using conventional and unconventional technologies

Type

Peer-reviewed article not indexed in WoS or Scopus

Language

en

Original abstract

This article is about the morphology problems on the surface of the steel sheet from corrosion resistant material. The conventional character technology used was cutting technology according to tables shears NTE3150/6.3.The following technology to treat one of the cut edges was milling technology. As a comparative technology was chosen wire method EDM (Electrical Discharge Machining) cutting. The surface morphology was compared after the next manufacturing operation which was bending, during different bending radius. Bends were performed on a special fixture with the possibility of setting bend radius step by step.

Keywords in English

corrosion resistant steel sheet, shearing, bending, surface morphology, wire electrical discharge machining

Released

2015-06-30

Publisher

Versita

Location

Velká Británie

ISSN

0354-3870

Journal

Journal for technology of plasticity

Volume

40

Number

1

Pages from–to

13–21

Pages count

8

BIBTEX


@article{BUT115310,
  author="Milan {Dvořák} and Milan {Kalivoda} and Karel {Osička} and Kateřina {Mouralová} and Martin {Slaný}",
  title="Surface sheets morphology during its division using conventional and unconventional technologies",
  journal="Journal for technology of plasticity",
  year="2015",
  volume="40",
  number="1",
  pages="13--21",
  issn="0354-3870"
}