Detail publikace

Surface sheets morphology during its division using conventional and unconventional technologies

DVOŘÁK, M. KALIVODA, M. OSIČKA, K. MOURALOVÁ, K. SLANÝ, M.

Anglický název

Surface sheets morphology during its division using conventional and unconventional technologies

Typ

Článek recenzovaný mimo WoS a Scopus

Jazyk

en

Originální abstrakt

This article is about the morphology problems on the surface of the steel sheet from corrosion resistant material. The conventional character technology used was cutting technology according to tables shears NTE3150/6.3.The following technology to treat one of the cut edges was milling technology. As a comparative technology was chosen wire method EDM (Electrical Discharge Machining) cutting. The surface morphology was compared after the next manufacturing operation which was bending, during different bending radius. Bends were performed on a special fixture with the possibility of setting bend radius step by step.

Klíčová slova anglicky

corrosion resistant steel sheet, shearing, bending, surface morphology, wire electrical discharge machining

Vydáno

2015-06-30

Nakladatel

Versita

Místo

Velká Británie

ISSN

0354-3870

Časopis

Journal for technology of plasticity

Ročník

40

Číslo

1

Strany od–do

13–21

Počet stran

8

BIBTEX


@article{BUT115310,
  author="Milan {Dvořák} and Milan {Kalivoda} and Karel {Osička} and Kateřina {Mouralová} and Martin {Slaný}",
  title="Surface sheets morphology during its division using conventional and unconventional technologies",
  journal="Journal for technology of plasticity",
  year="2015",
  volume="40",
  number="1",
  pages="13--21",
  issn="0354-3870"
}