Publication detail
Statistical evaluation width of kerf after WEDM by Analysis of Variance
MOURALOVÁ, K. KOVÁŘ, J. PROKEŠ, T. BEDNÁŘ, J. MATOUŠEK, R. KLAKURKOVÁ, L.
English title
Statistical evaluation width of kerf after WEDM by Analysis of Variance
Type
Scopus Article
Language
en
Original abstract
This paper presents an investigation on the effect and optimization of machining parameters on the width of kerf of titanium alloy (Ti-6Al-4V) using wire electrical discharge machining (WEDM). The experimental studies were conducted under varying Pulse off time, Pulse on time, Discharge current, wire speed and Gap voltage. The settings of machining parameters were determined by using Design of experiment. Statistical evaluation width of kerf by parameter settings on the machine was made using Analysis of Variance (ANOVA). Improved machining performance in the WEDM process has been achieved by using this approach.
Keywords in English
Design of Experiment, WEDM, electrical discharge machining, width of kerf, titanium Ti-6Al-4V, Analysis of Variance.
Released
2016-06-08
Location
Brno
ISSN
1803-3814
Volume
2016
Number
22
Pages from–to
301–304
Pages count
4
BIBTEX
@article{BUT125321,
author="Kateřina {Mouralová} and Jiří {Kovář} and Tomáš {Prokeš} and Josef {Bednář} and Radomil {Matoušek} and Lenka {Klakurková}",
title="Statistical evaluation width of kerf after WEDM by Analysis of Variance",
journal="Mendel Journal series",
year="2016",
volume="2016",
number="22",
pages="301--304",
issn="1803-3814"
}