Detail publikace

Statistical evaluation width of kerf after WEDM by Analysis of Variance

MOURALOVÁ, K. KOVÁŘ, J. PROKEŠ, T. BEDNÁŘ, J. MATOUŠEK, R. KLAKURKOVÁ, L.

Anglický název

Statistical evaluation width of kerf after WEDM by Analysis of Variance

Typ

Článek Scopus

Jazyk

en

Originální abstrakt

This paper presents an investigation on the effect and optimization of machining parameters on the width of kerf of titanium alloy (Ti-6Al-4V) using wire electrical discharge machining (WEDM). The experimental studies were conducted under varying Pulse off time, Pulse on time, Discharge current, wire speed and Gap voltage. The settings of machining parameters were determined by using Design of experiment. Statistical evaluation width of kerf by parameter settings on the machine was made using Analysis of Variance (ANOVA). Improved machining performance in the WEDM process has been achieved by using this approach.

Klíčová slova anglicky

Design of Experiment, WEDM, electrical discharge machining, width of kerf, titanium Ti-6Al-4V, Analysis of Variance.

Vydáno

2016-06-08

Místo

Brno

ISSN

1803-3814

Ročník

2016

Číslo

22

Strany od–do

301–304

Počet stran

4

BIBTEX


@article{BUT125321,
  author="Kateřina {Mouralová} and Jiří {Kovář} and Tomáš {Prokeš} and Josef {Bednář} and Radomil {Matoušek} and Lenka {Klakurková}",
  title="Statistical evaluation width of kerf after WEDM by Analysis of Variance",
  journal="Mendel Journal series",
  year="2016",
  volume="2016",
  number="22",
  pages="301--304",
  issn="1803-3814"
}