Results of Research and Development
End Mills with PCD Inserts Including Integral Chip Breaker
Publication results Year: 2019
POLZER, A. KŘEHLÍK, L. TRČKA, T.
Prediction of the Stamped Part Thinning Depending on Its Geometry and Blank Material
Publication results Year: 2019
ŘIHÁČEK, J. PODANÝ, K. FALTÝNEK, F.
Solar Absorber with a Structured Surface – a Way to Increase Efficiency
Publication results Year: 2019
MRŇA, L. ŘIHÁČEK, J. HORNÍK, P. ŠARBORT, M.
Analysis of subsurface defects occurrence in abrasion resistant Creusabro steel after WEDM including the study of morphology and surface topography
Publication results Year: 2019
MOURALOVÁ, K. PROKEŠ, T. BENEŠ, L. SLIWKOVÁ, P.
Study of vertical graphene growth on silver substrate based on design of experiment
Publication results Year: 2019
MOURALOVÁ, K. ZAHRADNÍČEK, R. BEDNÁŘ, J.
Material and technological investigation of machined surfaces of the OCHN3MFA steel
Publication results Year: 2019
BARÉNYI, I. MAJERÍK, J. POKORNÝ, Z. SEDLÁK, J. BEZECNÝ, J. DOBROCKÝ, D. JAROŠ, A. ECKERT, M. JAMBOR, J. KUSENDA, R.
Material and Technological Aspects while Processing of Selected Ultra High Strength Steel
Publication results Year: 2019
BARÉNYI, I. MAJERÍK, J. BEZECNÝ, J. KRBAŤA, M. SEDLÁK, J. JAROŠ, A.
Optimization of Deposition Parameters of a DLC Layer Using (RF) PECVD Technology
Publication results Year: 2021
PROKEŠ, T. MOURALOVÁ, K. ZAHRADNÍČEK, R. BEDNÁŘ, J. KALIVODA, M.
Analysis of the oxide occurrence on WEDM surfaces in relation to subsequent surface treatments
Publication results Year: 2019
MOURALOVÁ, K. PROKEŠ, T. BENEŠ, L.
Showed 2611–2625 from 2874 results