Sprung mass positioning by semi-actively controlled damper

Stať ve sborníku v databázi WoS či Scopus

en

Recently, the intensive wear of rails, especially in curves of small radii and at switches, has been studied. The wear is caused by the high lateral force peak of the wheel against the rail when entering the curves. An effective solution for reducing undesirable lateral forces on the rail is to rotate the vehicle bogie in the direction of the rail curve, which influences the distribution of lateral force over the first and second wheelset. This reduces the force peak and thus the track wear. The bogie rotation is nowadays realized by actuators, which replace the yaw dampers. However, actuator implementation is complicated, expensive, energyintensive and demanding for the performance of a fail-safe system. From this point of view, a semi-actively controlled yaw damper appears to be a better candidate. An algorithm such as Skyhook can hold the sprung mass in the desired position. It is believed to be possible to rotate the vehicle bogie by the special S/A control strategy of a yaw damper. This paper deals with the possibilities and limits of the positioning of the sprung mass by the semi-actively controlled damper. It has been shown that the system relative attenuation and the damper response time have the greatest influence on the mass positioning efficiency.

MR, yaw, damper, semi-active, sprung mass, positioning

2020-10-14

EDP Sciences

978-2-7598-9108-5

2261-236X

MATBUD’2020 – Scientific-Technical Conference: E-mobility, Sustainable Materials and Technologies

MATEC web of conferences

322

1

1–8

8