Detail publikace
Thermal Debinding of Injection Moulded Ceramics
TRUNEC, M. CIHLÁŘ, J.
Anglický název
Thermal Debinding of Injection Moulded Ceramics
Typ
Článek recenzovaný mimo WoS a Scopus
Jazyk
en
Originální abstrakt
Special equipment for thermal binder removal under controlled pressure conditions and with controlled gas flow rate was built to study the debinding process of injection moulded parts. The equipment was designed to record changes in the weight of injection mouldings, and an operating system made it possible to control by temperature their weight loss. The thermal debinding process of injection moulded parts prepared from fine alumina powder and thermoplastic binder system based on ethylene – vinylacetate copolymer and paraffin was studied using this equipment. The influence of pressure and flow rate of various gas atmospheres (air, oxygen, nitrogen, carbon dioxide and vacuum) was investigated. The benefit of binder removal in an inert atmosphere with controlled weight loss rate was described.
Klíčová slova anglicky
ceramics, injection moulding, binder removal defect
Vydáno
1997-01-01
Nakladatel
Elsevier Science
ISSN
0955-2219
Ročník
17
Číslo
2-3
Strany od–do
203–
Počet stran
7
BIBTEX
@article{BUT38724,
author="Martin {Trunec} and Jaroslav {Cihlář}",
title="Thermal Debinding of Injection Moulded Ceramics",
journal="Journal of the European Ceramic Society",
year="1997",
volume="17",
number="2-3",
pages="7",
issn="0955-2219"
}